@[email protected] to [email protected]English • 2 years agoDon't forget to change your z offset after swapping nozzlesmessage-square21fedilinkarrow-up187arrow-down12file-text
arrow-up185arrow-down1message-squareDon't forget to change your z offset after swapping nozzles@[email protected] to [email protected]English • 2 years agomessage-square21fedilinkfile-text
minus-square@[email protected]linkfedilinkEnglish3•2 years agoDid that this morning. Except for I didn’t hit save and restart after setting new offset in klipper. But I just got a small scratch. I got lucky it wasn’t too bad. Lol
Did that this morning. Except for I didn’t hit save and restart after setting new offset in klipper. But I just got a small scratch. I got lucky it wasn’t too bad. Lol