St3alth to [email protected]English • 3 months agoForklift drivers, what's one thing that you've done by accident that's always stuck with you since it happened?message-square60fedilinkarrow-up190arrow-down11file-text
arrow-up189arrow-down1message-squareForklift drivers, what's one thing that you've done by accident that's always stuck with you since it happened?St3alth to [email protected]English • 3 months agomessage-square60fedilinkfile-text
minus-square@[email protected]linkfedilink12•2 months agoI was using the forks as a workbench to cut a piece of 1/2" steel with an acetylene torch. I thought I had enough overhang to make it work. Those forks ended up about 1.5" shorter after I finished my cut.
minus-square@[email protected]linkfedilinkEnglish8•2 months agoSorry, but BOTH forks!? How did you not notice the first one falling off?
minus-square@[email protected]linkfedilink7•2 months agoHaha, that’s a good call. I certainly should have. I was pretty new with the torch so I suppose I was focused on the task at hand. And it was just the tip™️. The last inch or 2 on the fork of a small lift won’t make a lot of noise compared to the torch.
minus-square@[email protected]linkfedilink2•2 months agoChisel-toe tines are all the rage, this season!
I was using the forks as a workbench to cut a piece of 1/2" steel with an acetylene torch. I thought I had enough overhang to make it work.
Those forks ended up about 1.5" shorter after I finished my cut.
Sorry, but BOTH forks!?
How did you not notice the first one falling off?
Haha, that’s a good call. I certainly should have. I was pretty new with the torch so I suppose I was focused on the task at hand.
And it was just the tip™️. The last inch or 2 on the fork of a small lift won’t make a lot of noise compared to the torch.
Chisel-toe tines are all the rage, this season!